Dimensions
- Class: 1/18 nitro micro truck
- Front Width: 178mm
- Rear Width: 180mm
- Length: 208 mm
- Wheelbase: 150 mm
- Ready to run weight: 690g
Chassis:
- Chassis: Swiss T6 7075 CNC-machined chassis
- Upper deck: composite upper deck
- Body: 1/18 racing truck body
Drivetrain:
- Type: shaft-drive 4WD
- Drivetrain: aluminum main driveshaft
- Internal ratio: 1:2.5
- Drive shafts: composite front + rear
- Differentials: composite ball differentials – adjustable front + rear
- Bearings: 24 high-speed ball-bearings
- Brake system: adjustable brake; laser cut, hand-ground steel brake disk; Ferodo brake pads
Suspension:
- Front: fully independent
- Rear: fully independent
- Dampening: oil-filled coil-over shocks
- Servo saver: included (rugged)
Geometry:
- Camber: front/rear: -2° (preset)
- Caster: 12° (preset)
- Front Toe: toe-out 0.5° (preset)
- Rear Toe: toe-in 3.5° (preset)
- Anti-roll bars: 1.0mm front + rear (included)
- Wheelbase: 150 mm
Engine
- Engine powerful 0.8cc engine
- Engine mounts CNC-machined aluminum engine mounts
- Carburetor aluminum slide carburetor
- Muffler polished muffler
- Fuel tank 30cc fuel tank w/ hypertonic lid & internal stone-type filter
- Flywheel aluminum flywheel
- Clutch bell HUDY steel clutch bell
- Clutch shoes CNC-machined aluminum clutch shoes
- Fuel tubing silicone fuel tubing
Others:
- Wheels: XRAY micro truck wheels
- Tires: XRAY micro truck low pin rubber tires
- Instructions: full-color manual with 3D graphics
- Packing: carton box with 11 vinyl bags with parts
- Not included: radio system (transmitter and receiver), micro servos, lexan paint, fuel, glow plug heater, receiver battery





























Reviews
There are no reviews yet.